Back home

Certifications

The standards and compliance our e-bikes and workshop meet.

E-bike compliance

To be ridden on NSW public roads, an e-bike must meet the power-assisted pedal cycle requirements: a 250W continuous rated motor and a 25km/h pedal-assist cut-off. Where a SLEDZ model is supplied in that configuration, it is built to those requirements. Higher-output configurations do not meet the power-assisted pedal cycle definition and are intended for private land only. Check the specification sheet for the model you're considering, or ask us before you buy, and we'll confirm the configuration that applies to you.

Electrical safety

Our batteries and chargers are tested to UN38.3 and use certified Samsung 21700 cells with a battery management system (BMS) that protects against over-charge, over-discharge, over-current and short circuit.

Workshop standards

Our mechanics are trained across mechanical and e-bike systems. We follow manufacturer torque and diagnostic procedures and use calibrated tools.

Questions about this policy? Call the shop on 0485 688 834 or email hello@ezriderz.com.au.